Hi,
I am using the FX3 behind a USB Hub. The USB hub is controlled and configured by the FX3 as part of the system.
During development, the Hub has incorrect configuration which causes the FX3 Bootloader Device to be unavailable due to power requriement. When powering the system, the hub is configured as bus-powered. 100mA is available per port. Windows warns about "usb hub power exceeded" because the FX3 request 200mA on a 100mA port.
Despite the configuration being bus-powered, my system doesn't use any USB current and is powered externally during development and testing.
- Would there be a way to disable Windows USB current limitation during my development
Is there any registry key that would allow to disable USB Current limitation ? - Would there be a way to have the FX3 Bootloader device request only 100mA ?
Regards,
Stan